Page 1 of 1
Hanging proudly...
Posted:
Wed Aug 08, 2007 8:29 pmby Geoff
This is not for critique but more to say if you have a print that u like..then frame it. The one on the right is my avatar image and I've been meaning to frame it for ages...here's the result. Yep - the image on the left isn't quite straight and it was my bday present to Bel - our local beach (I didn't photograph this one). The image on the right was printed on the R1800 at A3 size:
Posted:
Wed Aug 08, 2007 8:34 pmby Bindii
They look good Geoff... I must admit that I am terrible when it comes to getting any of my images printed... I tend to print the family snapshots occasionally and nothing else...
Posted:
Wed Aug 08, 2007 8:36 pmby MATT
NIce work..
Whats your hanging system???
Cheers
MATT
Posted:
Wed Aug 08, 2007 8:39 pmby Geoff
Matt - something I installed last year...I'm just on my way out the door, will post more about it later. Commonly used in art galleries etc.
Posted:
Wed Aug 08, 2007 8:53 pmby W00DY
I second this...
I finally, well actually Rick finally, finished the frames for the two 24x30 prints I got from Pixel Perfect.
Whilst they are massive in our small house they look good and will look much better once we have a bigger space for them.
It is nice to see some prints up on the wall again.
Posted:
Mon Aug 13, 2007 5:42 pmby MATT
Geoff wrote:Matt - something I installed last year...I'm just on my way out the door, will post more about it later. Commonly used in art galleries etc.
More info or link Geoff if possible..
Cheers
MATT
Posted:
Mon Aug 13, 2007 5:54 pmby Geoff
Matt sorry for the delay.
This is the mob I used:
http://www.fxhangingsystems.com.au/
Based in Balmain.
I need to get some more clips etc for another wall in our unit soon actually.
The system works very well. Installation is a little messy but done properly it looks neat and tidy. We had to drill into red brick, very noisy and lots of dust but the end result was worth it. I use the
Locator (wall sytsem).
Hope this helps.
Posted:
Mon Aug 13, 2007 6:03 pmby MCWB
Posted:
Mon Aug 13, 2007 6:28 pmby MATT
Excellent ..Thanks it looks great.
MATT
Posted:
Mon Aug 13, 2007 7:51 pmby Yi-P
Geoff, how did you frame it? Did you let someone do it or you went for DIY?
I got couple of prints here sitting lonely without a frame...
Posted:
Tue Aug 14, 2007 12:40 amby Geoff
Yi-P wrote:Geoff, how did you frame it? Did you let someone do it or you went for DIY?
I got couple of prints here sitting lonely without a frame...
the one on the right Yi-p...I got done professionally at a local framers - the one one the left I bought as is
